- 产品参数
- 图文介绍
- 企业简介
- 企业地址
SKF加热装置 729659C 电热板加热板
Preparation for use • Place the TIH 030m in the horizontal position on a stable surface. • Connect the mains plug to a suitable mains supply. • Plug the remote control into the connector on the carrying handle side of the heater. • For workpieces with an internal diameter large enough to it over the inductive coil, follow these steps: - Place the workpiece over the inductive coil using appropriate lifting equipment. - For best performance, adjust the position of the workpiece so that the inductive coil is in the centre. - Position the largest yoke so that it completely covers the top of both vertical supports.
SKF加热装置 729659C 电热板加热板
• For workpieces that do not it over the inductive coil, follow these steps: - Choose the largest of the three yokes that it through the internal diameter of the workpiece. - If necessary, remove the top yoke from the TIH 030m. - Slide the workpiece onto the yoke that you have selected. - Position the yoke on the TIH 030m with the bright underside resting evenly on the two vertical supports. • If you will use TEMP MODE, plug the temperature probe into the connector on the carrying handle side of the heater. Place the magnetic end of the probe on the inner ring of the bearing or on the innermost surface of the workpiece. • Switch on the TIH 030m. • Observe the self-test of the remote control display and signal tone.
- 产品参数
- 图文介绍
- 企业简介
- 企业地址